[ns] "_o14 cmd" mistake when implementing new routing protocol

[NISCHAY BAHL]

Dear all
I am using ns 2.34 on red hat linux. All the wireless simulation codes on AODV or existing protocols are working fine. But when I am adding new protocol, I am able to make the simulator after running ./configure >> make clean >> make. But during execution of tcl file with new protocol code I am getting following errors. I have carefully implemented code step by step by thoroughly reading ns material on internet and ebooks. I shall be highly thankful to you.
Thanks 
N B
 
 
num_nodes is set 100
(_o14 cmd line 1)
invoked from within
"_o14 cmd addr"
invoked from within
“catch “$self cmd $args” ret”
invoked from within
“if [catch "$self cmd $args" ret] 
{set cls [$self info class]
global errorInfo
set savedInfo $errorInfoerror 
“error when calling class $cls: $args” $
…”(procedure “_o14″ line 2)
(SplitObject unknown line 2)
invoked from within"_o14 addr" 
("eval" body line 1) 
invoked from within 
"eval $node addr $args" 
("default" arm line 2) 
invoked from within 
"switch -exact $routingAgent_ 
{ DSDV { set ragent [$self create-dsdv-agent $node] }
 DSR { $self at 0.0 "$node start-dsr" }
 AODV { set ragent [$self cre..." (procedure "_o3" line 11) (Simulator create-wireless-node line 11) invoked from within "_o3 create-wireless-node" ("eval" body line 1) invoked from within "eval $self create-wireless-node $args" (procedure "_o3" line 23) (Simulator node line 23)invoked from within"$ns node"("for" body line 2)invoked from within"for {set i 0} {$i < $val(nn) } { incr i } {sey mnode_($i) [$ns node]}"Nischay Bahl